Microphone · not the speaker
You hear them fine. They can't hear you.
That's a microphone problem, not a speaker one — a different opening, usually blocked by the same dust and lint. Clear it, then test it before you trust it on your next call.
- Dust Buster clears the mic grille
- Record & playback confirms it worked
- Nothing uploaded — stays in your browser
Find the small microphone hole — usually on the bottom edge — and hold it face-down over a cloth.
Mic test
Records 3 seconds of audio and plays it straight back, so you can hear what your mic actually picks up.
Quick answer
If people say you sound muffled or quiet on calls, your microphone is blocked — not your speaker. Find the mic hole (usually a pinhole on the bottom edge), hold that edge facing down, and run the Dust Buster mic cleaner sound for 30 seconds, or Water Ejector if the phone got wet. Wipe the opening, then use the Mic Test on this page: it records three seconds and plays them back so you hear exactly what callers hear. The recording never leaves your browser.
| Where the mic is | What it's used for |
|---|---|
| Bottom edge, next to the charging port | Main mic for calls and voice notes |
| Top edge or near the earpiece | Noise cancellation, speakerphone |
| Back, beside the camera | Video recording, noise cancellation |
Is it safe, and what it can't fix
Run short cycles and stop if the sound distorts or the phone gets warm. A cleaner sound may help loosen dust and clear small droplets at the opening; it can't dry the inside of a phone, repair a damaged microphone, or fix a wet charging port.
Phones without a water-resistance rating are at higher risk if they get wet. If yours was submerged, power it off and have it serviced rather than relying on sound.
Sources
This guidance follows the manufacturers' own support pages:
Speaker problem or mic problem?
They're easy to confuse because both show up as "bad call quality." The test is simple: if you can't hear them, it's your speaker or earpiece. If they can't hear you, it's your microphone.
-
1
Find the mic hole
Usually a pinhole on the bottom edge near the charging port, sometimes a second one on the back near the camera.
-
2
Run Dust Buster
The 3,000–9,000 Hz sweep vibrates surface dust and lint out of the opening.
-
3
Wipe gently
A soft, dry microfiber cloth over the opening picks up whatever the sweep loosened.
-
4
Record and confirm
Use the Mic Test panel above — don't rely on a call to find out, test it privately first.
Case covering the mic?
Before assuming it's dust, check whether a phone case's cutout lines up with the mic hole. Misaligned cutouts on cheaper cases are a common, completely unrelated cause of muffled calls.
If it's your earpiece instead
If people can hear you fine but you can't hear them, the problem is on the other side of the call — see the call speaker & earpiece cleaner instead.
Mic problem, speaker problem, or settings?
| What happens | Likely cause | Fix |
|---|---|---|
| Callers hear you muffled or far away | Blocked main mic | Dust Buster + gentle brush, then Mic Test |
| Fine on handset, bad on speakerphone | Blocked secondary mic | Clean the top and back mic holes too |
| Voice notes silent, calls fine | App microphone permission | Allow microphone access in Settings for that app |
| You can't hear callers | Earpiece, not mic | Call speaker cleaner |
| Muffled only with a case on | Case cut-out misaligned | Change the case |
| Everything silent after water | Water in the mic port | Air-dry, Water Ejector, retest in an hour |
How to clean a phone microphone safely
Microphone holes are even smaller than speaker holes, and the membrane behind them is delicate. Work from the outside only.
- Run the mic cleaner sound. Dust Buster's 3,000–9,000 Hz sweep vibrates the surrounding grille and helps loose dust drop out. Hold the mic edge facing down.
- Brush lightly across the hole with a clean, dry, soft toothbrush.
- Lift lint with low-tack tape or cleaning putty pressed on and peeled away.
- Record and compare with the Mic Test above. A clean mic sounds as clear as your voice in the room.
Never push a SIM pin, needle or toothpick into the mic hole, blow compressed air into it, or use liquids. Apple's own guidance for AirPods and iPhone openings is dry cotton swabs and soft brushes only.
After water
A wet mic makes your voice sound muffled or crackly to others until it dries. Run Water Ejector with the bottom edge down, leave the phone in moving air, and retest with the Mic Test after an hour. The full routine is in dropped your phone in water? The first 10 minutes.
How the online mic test works
When you tap record, your browser asks for microphone permission. The test captures three seconds with the MediaRecorder API, shows a live input-level meter, and plays the clip back. It's the quickest way to check a phone, laptop or headset microphone without calling anyone.
Privacy
The recording is kept in your browser's memory only. It isn't uploaded, stored or shared, and it's discarded when you leave the page. You can revoke microphone permission at any time in your browser settings. See the privacy policy.
Mic not working after water?
A wet microphone opening makes your voice sound muffled, crackly or silent until it dries. If the phone was submerged, or the screen or buttons are acting up, power it off and have it checked instead of relying on sound.
For a splash or brief exposure: hold the mic edge facing down on a cloth, run Water Ejector to help push droplets out of the opening, then leave the phone in moving air and retest with the Mic Test after an hour. If it still sounds muffled the next day, water may have reached the microphone itself, and it needs service. The full first-ten-minutes routine is in what to do if you dropped your phone in water; crackling that isn't water-related is covered in phone speaker crackling or distorted.
Call mic cleaner: for calls, not just recordings
Your call microphone is usually the pinhole on the bottom edge. If callers say you sound distant, or you only have trouble on speakerphone, also clean the secondary mic holes on the top edge and back, then run the Mic Test in both handset and speakerphone positions. If it's the other way round and you can't hear them, that's the earpiece: use the call speaker cleaner.
Phone microphone cleaner vs. cleaning sprays
Searches for "mic cleaner" mostly return sprays and wipes made for studio microphones, and AI tools that remove background noise. This page is neither: it's a sound-based tool for the tiny opening of a phone microphone, plus a test to confirm the result. Never spray liquid into a phone's mic hole.
Mic test says blocked, busy or not found?
- Blocked: your browser or phone denied microphone access. Allow it for this site (the lock or mic icon next to the address bar), and check that your browser itself has microphone permission in your phone's settings. Then reload and try again.
- No microphone found: disconnect any headset or Bluetooth device that may be set as the input, or pick the right input in your browser, then retry.
- Busy or unavailable: another app, such as a call, a video app or a voice recorder, may be using the mic. Close it and try again.
- Only one app has the problem: check that app's microphone permission in Settings. If the Mic Test works here, the microphone hardware is fine.
Mic cleaning questions
Can sound clean my microphone?
Dust Buster's high-frequency sweep vibrates the mic grille the same way it vibrates a speaker grille, which can loosen surface dust and lint. It can't remove anything lodged inside the housing itself.
How do I test if my microphone still works?
Use the Mic Test panel on this page — it records 3 seconds through your microphone and plays it back immediately, so you hear exactly what a call partner would hear.
Why does my voice sound muffled or quiet to other people?
Most often a blocked mic grille — usually a small hole on the bottom edge or back of the phone. Also check that a case isn't partially covering the opening.
Does this use my microphone recording for anything else?
No. The test recording stays in your browser, plays back locally, and is discarded when you leave the page. Nothing is uploaded.
What is a mic cleaner sound?
It's a tone that vibrates the grille around your phone's microphone to loosen dust or water. On this page, Dust Buster (a 3–9 kHz sweep) is used for dust and Water Ejector (165 Hz) after water exposure.
How do I fix my mic speaker?
"Mic speaker" problems are usually one of two things: callers can't hear you (clean the microphone with this page) or you can't hear callers (clean the earpiece with the call speaker cleaner).
Can I test my microphone online?
Yes. The Mic Test on this page records three seconds and plays it back instantly, entirely in your browser. It works on phones, laptops and headsets.
How do I clean my iPhone microphone?
Run Dust Buster with the bottom edge facing down, brush the mic holes gently with a soft dry brush, then record a test clip. Don't insert anything into the holes.